When the conveyor belt is running, the height of the two edges is changed when the conveyor belt is running. While the other side is low, the material from the low side of the sprinkled, the disposal method is to adjust the conveyor belt deviation.The conveyor belt is suspended when the radius of curvature of the concave section is small.Because the conveyor belt has left the slot roller group, the general groove angle becomes smaller, so that the local material spilled out.In the mobile mechanical loading machine, heap reclaimer equipment in order to shorten the tail car and the concave section of this design into a non-circular transition interval, when the width of the conveyor belt when the selection is relatively easy to spread.Guide trough at the time of the design of the distance from the conveyor belt longer rubber skirt longer material out of the guide trough, pay attention to regular maintenance.
Select the conveyor belt to accurately specify the specific material name, nature. Especially the size, temperature, whether it has acid, alkali and other corrosive and special requirements.To specify the specific application sites, requiring specifications width, length, number of layers, thickness, especially heat-resistant conveyor belt temperature and transport size.Conveyor belt in the transport and storage, the temperature should be maintained between 18-40 ℃, relative humidity should be maintained at between 50-80%, adhere to clean to prevent direct sunlight or rain and snow leaching, to prevent with acid, alkali, oil , Organic solvents and other substances in contact, and away from the heating device one meter away.
Conveyor belt during storage, the product must be placed in volume, not folded, should be a quarter of a conveyor belt.Conveyor belt surface cleaning: First, the sensitivity of the needle detector should be adjusted to the lowest level, such as needle detector B / C mode, please adjust the needle detector to C mode, so as not to affect the next high sensitivity of the cleaning work.And then pull the towel and properly press the surface of the conveyor belt, start the machine, so that the machine running more than five laps, the towel washed and wring dry, repeat this step until the conveyor belt surface no obvious pollutants;Conveyor belt cleaning: Wash the towel and wring dry, from the lower part of the machine towel through the bottom of the conveyor belt, straighten the towel, and towel to the front of the conveyor, grasp the towel at both ends, the machine to run the machine for several weeks.
Since the bottom of the conveyor belt is the dirtiest place, it is necessary to wipe it several times.
After passing the two cleaning steps, adjust the sensitivity to 8 or the highest sensitivity, start the machine, let the machine run.If the machine is running smoothly and the probe metal position indicator light does not shine, this time into the clothing without any metal impurities, clothing can pass through the needle detector channel, that conveyor belt clean success.Such as still found after turning on the probe light flashing, and clothing can not pass, may not be clean, need to clean again. Note: After cleaning the test, you need to avoid the surrounding interference of environmental factors.