Tongxiang is one of the conveyor equipment manufacturers in China.We have a lot of professional knowledge on the conveyor belt.The scattering of belt conveyors is a common problem. There are many reasons. But the emphasis is still on strengthening daily maintenance and maintenance. We txroller are special on conveyor rollers for more than 30 years.

1. Sprinklers at the transfer point Sprinklers at the transfer point are mainly at the hopper, feed chute, etc. If the belt conveyor is heavily overloaded, the belt chute of the belt conveyor is damaged, and the steel plate at the guide slot is far from the belt and the rubber skirt is longer so that the material rushes out of the guide slot. The above situation can be solved in terms of controlling the transport capacity and strengthening the maintenance.

2. When the concave section of the belt is suspended, the belt section of the spreading concave section will cause the belt to hang when the radius of curvature of the concave section is small. At this time, the groove forming condition of the belt changes, because the belt has left the grooved roller group, and the general groove angle Become smaller and spread out some of the material. Therefore, a larger radius of curvature of the concave segment should be used as much as possible during the design phase to avoid such occurrences. For example, in the mobile mechanical ship loader and stacker-reclaimer equipment, in order to shorten the tail car, the concave section is designed to have a non-arc transition zone, and it is easier to spread the material when the belt width is less selected.

3. The spread of the spoiled belt during deviation is due to the change of the two edge heights of the belt during operation. The height of one side is high, while the other side is low, and the material is scattered from the low side. The processing method is to adjust The deviation of the belt.

We also supply variousconveyor accessories,such as belt conveyor idler roller,mining crushing cement conveyor and so on.If you need,please contact us.